Baby’s StoryTime Quilt


A couple weekends ago I attended a baby shower for the most stylish mom-to-be I have ever known. Seriously, she’s so classy I wish I was her. Anyways, the invitation I received asked if I would contribute a children’s book for story time, I decided to continue the story time theme and also make her baby girl this pretty quilt to snuggle into while mom reads her favorite tales.

This little quilt was very simple as it was my first and didn’t take much time to piece together as I stuck with simple strips instead of squares. I cut 2 pieces of fabric the size of my large rubber cutting mat (a simple and easy measurement to make). I also cut one piece of batting the same size. Next I took one of the pieces of fabric and cut it into 4-1/2 in. strips.

Once all my cutting was complete, I placed two strips together, right sides facing each other and sewed up the one long side, 1/4 in. from the edge. I unfolded those two strips and aligned a third strip next to the second strip, once again with right sides facing each other and sewed 1/4 in. in from the edge. Now unfolded, I have three connected strips of fabric. Continue to join strips until all are combined into one piece. Iron flat.

Place a piece of batting on the wrong side of the pieced together square of fabric. Pin together. Now sew along the lines that join each individual strip of fabric. This is how we are going to get a quilted look (see below).

batting sew lines

Once you have sewn down all the lines, lay the untouched piece of fabric (the back piece with no stitching) right side up, then place the pieced-together fabric with batting right side down (batting up). So the batting is on top, attached to the wrong side of the front of the quilt and the right side of the front of the quilt is facing down and touching the right side of the back of the quilt. Confused yet?

Now pin the pieces together. Your top piece will most likely be a bit smaller than the other two pieces so once pinned, take your rotary cutter and trim the edges to match the size of the top piece. Now comes the sewing. Sew around all 4 edges of the fabric pieces, leaving a 4-5 in. opening on one of the long sides. Make sure you capture all the layers as you sew around the quilt.

Now, reach into the opening and pull the opposite corners through the slit, essentially turning your blanket inside out or in reality, right side out. Once this is done. Iron all the edges and iron under the small section that was left open. Sew a 1/4 in. from the edge all the way around the blanket making sure to catch the fabric at the opening in your sew line (see below).

quilted edges

That’s it. You should now have a very sweet little baby quilt. Now that you have the general idea you can make another attempt and add ribbon along the edges, switch up the fabric strip patterns and textures, or switch to squares instead of strips. Good luck!